ISO 7077-1981 PDF

Full title and description

St ISO 7077-1981 — Measuring methods for building — General principles and procedures for the verification of dimensional compliance. This international standard defines the general principles and procedures to be applied when carrying out dimensional compliance control measurements in building construction, covering measurements for setting out, component manufacture and assembly, and the building as a whole.

Abstract

Provides general principles and procedures for verifying dimensional compliance in building construction. It sets out how compliance measurements should be planned and executed so that setting-out, prefabrication and assembled building elements meet specified dimensional requirements; the guidance applies to all types of building construction.

General information

• Status: Published (international standard, confirmed).
• Publication date: October 1981.
• Publisher: International Organization for Standardization (ISO).
• ICS / categories: 91.200 (Building and civil engineering works).
• Edition / version: Edition 1 (1981-10).
• Number of pages: 2.

Key bibliographic and lifecycle details (status, date, edition and page count) are recorded on the ISO catalogue and related standards catalogues.

Scope

Applies to the planning and performance of dimensional compliance control measurements for buildings. The standard addresses measurement principles and basic procedures used to verify that individual components, assemblies and the completed building conform to specified dimensions and tolerances. It is intended to be applicable across building types and construction methods where dimensional verification is required.

Key topics and requirements

• Principles for planning dimensional compliance measurements (purpose, reference points and measurement strategy).
• Procedures for carrying out dimensional checks on setting-out, components, and assemblies.
• Requirements for documenting measurement results and declaring conformity or non-conformity.
• Guidance on measurement traceability, reference lines/points and tolerance interpretation.
• Applicability across different building types and construction stages (prefabrication, on-site assembly, final verification).

Typical use and users

Used by architects, structural and site surveyors, quality managers, site engineers, prefabrication and assembly teams, building inspectors, test laboratories and standards committees involved in construction measurement and quality assurance. Typical use cases include establishing measurement procedures for setting-out, verifying prefabricated elements, quality control during installation and final dimensional acceptance checks.

Related standards

Related material includes other ISO and national standards concerned with building measurement, construction tolerances and site surveying produced by ISO/TC 59 and associated technical committees. Users commonly refer to companion standards on building tolerances, surveying practices and measurement instruments when applying ISO 7077.

Keywords

dimensional compliance, measuring methods, building measurement, verification procedures, setting-out, tolerances, construction quality, ISO 7077:1981.

FAQ

Q: What is this standard?

A: ISO 7077:1981 is an international standard that defines general principles and procedures for verifying dimensional compliance in building construction (measurements for setting-out, components, assemblies and the finished building).

Q: What does it cover?

A: It covers planning and performing dimensional compliance control measurements, documentation of results, and general guidance on applying measurement procedures and tolerances across different types of building construction.

Q: Who typically uses it?

A: Architects, site and structural surveyors, construction quality managers, site engineers, manufacturers of prefabricated building elements, building inspectors and standards developers use it to establish and verify dimensional conformity.

Q: Is it current or superseded?

A: The ISO catalogue lists ISO 7077:1981 as a published international standard (Edition 1, 1981) that has been subject to ISO review and confirmation; the record shows the edition remains published/confirmed in the ISO catalogue. Users should check the ISO catalogue or national standards body for the absolute latest lifecycle status before relying on the standard for procurement or compliance.

Q: Is it part of a series?

A: ISO 7077 is one item within the portfolio of ISO standards addressing measuring methods and construction practices maintained by ISO/TC 59; while not explicitly titled as a multi-part series, it is commonly used alongside other ISO and national standards on building measurement and tolerances.

Q: What are the key keywords?

A: Dimensional compliance, measuring methods, building construction, verification, setting-out, tolerances, measurement procedures, ISO 7077.