TDS PDF
Methods for chemical analysis of ferroniobium (Amendment 1; combined 80-page file- the complete four-page Amendment 1-2006 block on physical pages 1–4 and the supplied 1982 base on physical pages 5–80. Completeness of the base ending is unconfirmed- its text refers to printed page 75, but preserved numbering ends at printed page 73; the extent of any missing material is not established. Status and successor refer only to Amendment 1-2006; this is not an integrated corrected edition of the base) Original standard JIS G 1328-1982 AMD 1-2006 in PDF. Additional info + preview on request
Document status: Active
Crimped wire cloth (combined 20-page file- Errata dated 19 September 2003 on physical page 1, the 2002 edition on pages 2–12, and the 1983 edition on pages 13–20. The erratum quotes “Type of symbol”, whereas the included 2002 text reads “Type and symbol”; applicability of that correction to this copy is unconfirmed. Status and successor refer only to the included 2002 edition. The included 1983 edition was replaced by JIS G 3553-2002. This is not an integrated corrected edition) Original standard JIS G 3553-2002 ERRATA-2003 in PDF. Additional info + preview on request
Document status: Active
Iron ores — Methods for determination of tin content (supplied nine-page source; completeness of the ending is unconfirmed- Annex 2 ends after clause 6 on preparation of the calibration curve, and the subsequent calculation is absent from this file; the extent of any missing material is not established) Original standard JIS M 8227-1997 in PDF. Additional info + preview on request
Document status: Replaced by
Bicycles — Frame parts (withdrawn on 2010-05-20 with integration into another standard; the direct dated target remains unresolved because publisher metadata names JIS D 9401-1997 and distributor indexing names 2010; blank successor does not mean no replacement). Original standard JIS D 9403-2004 in PDF. Additional info + preview on request
Document status: Replaced by
Ships’ Cross Bitts. Original standard JIS F 2804-1973 in PDF. Additional info + preview on request
Document status: Replaced by St JIS F 2804-1976
Tooling Dimensions for the Straight-side Mechanical Presses. Limited source- the ends of two right-hand notes to Attached Table 9 are clipped on printed page 35; the original foldout-sheet composition has not been independently confirmed. Original standard JIS B 6451-1975 (1984) in PDF. Additional info + preview on request
Document status: Replaced by